Sets in Constraints editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Sets in Constraints editor

Post by Mark McCallum »

I had a quick dig around and couldn't find anything.
So I thought I'd ask the collective Ecabs mind.

Once you create a set in the Constraints Manager, can you uncreate it to re-edit? I was trying to change diameters and don't think I can ungroup it?
Also can you copy and paste sets within the CM, I tried a few ways but I don't think so. Just looking for confirmation?
Geometry sets.JPG
Any feed back appreciated.
Thanks
Mark
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Sets in Constraints editor

Post by Clint Buechlein »

Mark,

To undo a Set, choose the delete like you would to do a dimension and then select the set icon (the green S with the green circle on it). That will ungroup them from a set, you can make your changes and recreate the set.

-Clint-
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Sets in Constraints editor

Post by Mark McCallum »

Thanks Clint.
That makes sense.
Post Reply