Is it possible?

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Is it possible?

Post by Donald Thomson »

Is it possible to set M&T depths different for left and right side of a cabinet? Sometimes I would like to have a .375" deep mortise on one side and a .5" deep mortise on the other side.

Thanks!

Don
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Leo Graywacz
Guru Member
Posts: 640
Joined: Tue, Jan 16 2007, 7:56PM
Company Name: LRG WoodCrafting
Location: Windsor Locks, CT
Contact:

Re: Is it possible?

Post by Leo Graywacz »

Just went into the editor and it doesn't look like it's possible. There seems to be one parameter for depth, nothing to indicate right vs left.
Dell Precision 7710
Intel Core i7-6820HQ @ 2.70GHz 16.00 GB RAM
NVIDIA Quadro M3000M
512 GB PCIe NVMe - M.2 SSD
Win 7 Pro 64-bit

http://lrgwood.com
Scott Marshburn
Guru Member
Posts: 837
Joined: Sat, Mar 05 2011, 7:29AM
Company Name: Heritage WoodWorks
Country: UNITED STATES
Location: Jacksonville Nc
Contact:

Re: Is it possible?

Post by Scott Marshburn »

I am able to alter the dado depths on a deck for full dados by setting the dado depth on the deck too.5".Then setting the left inset too.125 however, for some reason this method will not work for blind dadoes.
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:

Re: Is it possible?

Post by Donald Thomson »

Thanks guys. That's what I was afraid of. Maybe the programmers can figure out if there is a way to do this?
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Post Reply