Profile edge issue

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

JR Allen
Junior Member
Posts: 62
Joined: Sun, Mar 16 2014, 1:48PM
Company Name: JRs Woodworx
Country: UNITED STATES

Profile edge issue

Postby JR Allen » Mon, Jan 27 2020, 5:11PM

Has anyone else experienced a glitch when you select Partial in the profile edge window and select 1 edge okay but when selecting a second edge it selects all 4 edges like a Chain. Seems like I used to be able to profile 3 edges for my tops.

profile edge.jpg

Carmen Addamo
Senior Member
Posts: 116
Joined: Sun, Oct 19 2014, 8:33PM
Company Name: Frank Raffaele and Sons Custom
Country: UNITED STATES

Re: Profile edge issue

Postby Carmen Addamo » Tue, Jan 28 2020, 10:08PM

I haven't experienced this issue but you could take the piece into contour area, Create edges and then delete the edge(s) you desire. Back to part editor and run the edge profile.

tim lucas
Guru Member
Posts: 317
Joined: Thu, Nov 29 2007, 5:18PM
Company Name: Tim Lucas Custom Woodworks LLC
Country: UNITED STATES
Location: bell, florida
Contact:

Re: Profile edge issue

Postby tim lucas » Wed, Jan 29 2020, 7:02AM

Jr

in my test if I click on the bottom next all sides are selected, if I click the top next just the left and top are selected
so it looks like the profile is working correctly. Hope this helps

Tim
profile tool.JPG
Tim Lucas Custom Woodworks LLC
www.TLCW.us

Mark McCallum
Guru Member
Posts: 347
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Profile edge issue

Postby Mark McCallum » Fri, Jan 31 2020, 4:39AM

Hi JR
Just testing and yes I experience a similar thing.
In the attached piece it has pockets
I can select the bottom edge
click the left hand edge and it selects 3 more edges or says there was a para solid error creating a new part body.
If I remove part editor parts from entire cabinet in the cabinet editor and try again in the part editor I select the bottom edge can only select either the left hand or right hand side and the selection stops.
Center styles Drill holes only.hsf
(486.02 KiB) Downloaded 56 times


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 13 guests