Adjustable Shelf Holes

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Chris B Campbell
Junior Member
Posts: 94
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Adjustable Shelf Holes

Postby Chris B Campbell » Mon, Apr 13 2020, 3:26PM

Hey All,
Never had this problem before when using 3/4" material. Today I built a .465 Baltic Birch box with same for adjustable shelfs. Shelf Holes are .1965" (5mm) at .375" deep. Should be no problem but trying to CNC at the router I am getting, Need to set up a tool for drilling .... ARGH! it is, it's tool #1.
So I tried a piece of 3/4" material with same hole, no problem at the router.
Best I can figure it's got something to do with material thickness, just cant figure out what?

Any help out there,
Thanks, Chris

Clint Buechlein
Thermwood Team
Posts: 493
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Adjustable Shelf Holes

Postby Clint Buechlein » Mon, Apr 13 2020, 3:48PM

Chris,

Make sure if you are using Groups in Control Nesting that the 5mm tool is set up in that Group. You may be expecting it in a specific Group, but it is actually in another without that tool. If you are on verision 6.12 or newer in Control Nesting, with that material nested, you should be able to go to Settings and it will tell you the Group that material is in at the bottom right. This will work if that nested material is displayed when you go to Settings. If all looks well, post an export from Control Nesting and I'll take a look at it.

-Clint-

Chris B Campbell
Junior Member
Posts: 94
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

Re: Adjustable Shelf Holes

Postby Chris B Campbell » Mon, Apr 13 2020, 4:22PM

thanks Clint,
I just did "Ignore all groups" and got it going...
Thanks again Clint.
Stay Well,
Chris


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 50 guests