Hi,
I'm working on a fishbone patter consisting over 200 lines. Is there a way to either join the lines or select more than one line at a time in profile edge? It takes forever trying to set a tool for each individual line and the program keeps crashing all the time (and I lose all my work of course in the process.)
Any solutions to this problem?
contour management / profile cut
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Nicholas Kiss
- Junior Member
- Posts: 31
- Joined: Wed, Nov 22 2017, 2:09PM
- Company Name: Clearcut
- Country: CANADA
-
Mark McCallum
- Guru Member
- Posts: 510
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Re: contour management / profile cut
Hi Nicholas
I think more information might get you some better help.
Perhaps some photos or screenshots can help
Are you working in ecabs or in the profile modeler?
I think more information might get you some better help.
Perhaps some photos or screenshots can help
Are you working in ecabs or in the profile modeler?
-
Clint Buechlein
- Thermwood Team
- Posts: 698
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: contour management / profile cut
Nicholas,Nicholas Kiss wrote:Hi,
I'm working on a fishbone patter consisting over 200 lines. Is there a way to either join the lines or select more than one line at a time in profile edge? It takes forever trying to set a tool for each individual line and the program keeps crashing all the time (and I lose all my work of course in the process.)
Any solutions to this problem?
There is not a way to select more than one line at at time to apply a profile. If some of the lines are connected, the Chain selection will select more than one.
-Clint-