Fixed shelf losing constraints

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Fixed shelf losing constraints

Postby Mark McCallum » Thu, Dec 10 2020, 12:28AM

Hi Guys
Is this repeatable for anyone else?
In the attached cabinet I am losing the front and back insets when I adjust the cabinet construction settings.
So take into shelf editor.
S
Highlight green both shelves
C for construction settings
Then Fixed shelf construction parameters
Then flip, tenon bottom side to reverse the tenon face side
then ok to go back
then ok to go back again. The cabinet rebuilds and looses the fixed shelf construction settings

It also happens when adjusting the tenon gap, for example 20 to 40mm
Thanking you
Mark
Andrew step base.jpg
Andrew step base.jpg (7.6 KiB) Viewed 4477 times
Andrew step base.hsf
(1.11 MiB) Downloaded 296 times

Clint Buechlein
Thermwood Team
Posts: 693
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Fixed shelf losing constraints

Postby Clint Buechlein » Thu, Dec 10 2020, 11:03AM

Mark,

This is as expected. When you select multiple shelves the construction settings that load are what the default settings are. You then apply the default settings to both shelves so your insets are now what the defaults are. You'll need to select one shelf, make changes, next shelf, make changes, etc.

-Clint-

Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Fixed shelf losing constraints

Postby Mark McCallum » Thu, Dec 10 2020, 4:41PM

Okay, that make sense.
Thanks Clint


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Ahrefs [Bot] and 13 guests