Edit depth of holes done with part editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 61
- Joined: Sat, Sep 02 2017, 7:30PM
- Company Name: Gene Davis Builder
- Country: UNITED STATES
Edit depth of holes done with part editor
Can this be done? I placed a lot of 6mm dia. holes in a collection of parts and now want to change the depth from 3/8" to 5/8". I cannot seem to select a hole for edit.
-
- Thermwood Team
- Posts: 702
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Edit depth of holes done with part editor
In Constraint Manager you can select, Edit, then Edit Depth. Or you can apply a depth constraint to them and modify the constraint.Gene Davis wrote:Can this be done? I placed a lot of 6mm dia. holes in a collection of parts and now want to change the depth from 3/8" to 5/8". I cannot seem to select a hole for edit.
-Clint-
-
- Junior Member
- Posts: 61
- Joined: Sat, Sep 02 2017, 7:30PM
- Company Name: Gene Davis Builder
- Country: UNITED STATES