Holy #*&% !!!!!!!

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Mike Farrington
New Member
Posts: 9
Joined: Wed, Mar 28 2007, 9:31AM

Postby Mike Farrington » Wed, Dec 12 2007, 6:48PM

yes that is it. What the heck am I doing wrong.

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Re:

Postby DanEpps » Wed, Dec 12 2007, 6:54PM

Mike Farrington wrote:What the heck am I doing wrong.


It ain't just you... :(

I think we are missing something in Mike's instructions. I'll keep playing with it and see where we are going wrong.

Mike Farrington
New Member
Posts: 9
Joined: Wed, Mar 28 2007, 9:31AM

Postby Mike Farrington » Wed, Dec 12 2007, 7:02PM

Well I dont feel so bad if a wizard cant figure it out. You would think a little expecto patronum would work on it, but I guess Im wrong.

If any one out there can help please feel free to jump in.

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Wed, Dec 12 2007, 7:47PM

Whew...finally got it after looking for another thread like this one. Mike had posted some more detailed instructions along with a simpler method in this thread.

Here is another threadthat uses another method.

Here are my results from following the instructions in the first thread above.
Attachments
stopped Flutes.jpg
stopped Flutes.jpg (42.1 KiB) Viewed 1890 times

Mike Farrington
New Member
Posts: 9
Joined: Wed, Mar 28 2007, 9:31AM

Postby Mike Farrington » Thu, Dec 13 2007, 1:41AM

OK I got it figured out. Thanks DanEpps, that link was just great. I am now setup so that I can quickly produce fluted columns on eCabs. Up untill today I could make them faster in the shop than on the computer, that is not the case any longer. :roll:


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 38 guests