Holy #*&% !!!!!!!

Mike Farrington · Postby **Mike Farrington** » Wed, Dec 12 2007, 6:48PM

yes that is it. What the heck am I doing wrong.

DanEpps · Postby **DanEpps** » Wed, Dec 12 2007, 6:54PM

Mike Farrington wrote:What the heck am I doing wrong.

It ain't just you...

I think we are missing something in Mike's instructions. I'll keep playing with it and see where we are going wrong.

Mike Farrington · Postby **Mike Farrington** » Wed, Dec 12 2007, 7:02PM

Well I dont feel so bad if a wizard cant figure it out. You would think a little expecto patronum would work on it, but I guess Im wrong.

If any one out there can help please feel free to jump in.

DanEpps · Postby **DanEpps** » Wed, Dec 12 2007, 7:47PM

Whew...finally got it after looking for another thread like this one. Mike had posted some more detailed instructions along with a simpler method in this thread.

Here is another threadthat uses another method.

Here are my results from following the instructions in the first thread above.

Mike Farrington · Postby **Mike Farrington** » Thu, Dec 13 2007, 1:41AM

OK I got it figured out. Thanks DanEpps, that link was just great. I am now setup so that I can quickly produce fluted columns on eCabs. Up untill today I could make them faster in the shop than on the computer, that is not the case any longer. :roll:

Thermwood / eCabinet Systems

Holy #*&% !!!!!!!

Re:

Who is online