Thermwood / eCabinet Systems

Mark P Sullivan · Post by **Mark P Sullivan** » Sat, Dec 30 2006, 11:11AM

When I take this assembly into the drawer door editor the system crashes, check it out.
Mark

DanEpps · Post by **DanEpps** » Sat, Dec 30 2006, 12:45PM

Mark

You have to zip assembly files before posting them.

Kerry Fullington · Post by **Kerry Fullington** » Sat, Dec 30 2006, 1:16PM

Dan,
I finally gave up and downloaded another browser so I could download the .esa files.

Mark,

I am getting the same thing. When I try to go to the Door/Drawer front editor it crashes eCabinets. I bet the guys at eCabinets will want to look at this when they get back in the office.

Kerry

Mark P Sullivan · Post by **Mark P Sullivan** » Sat, Dec 30 2006, 1:49PM

sorry here it is zipped
mark

DanEpps · Post by **DanEpps** » Sat, Dec 30 2006, 3:50PM

Kerry Fullington wrote:Dan,
I finally gave up and downloaded another browser so I could download the .esa files.

Mark,

I am getting the same thing. When I try to go to the Door/Drawer front editor it crashes eCabinets. I bet the guys at eCabinets will want to look at this when they get back in the office.

Kerry

kerry--What browser--Firefox?

Mark--I crash too when I try it.

Kerry Fullington · Post by **Kerry Fullington** » Sat, Dec 30 2006, 5:05PM

Dan,
I tried the Netscape. I think it is Mozilla just like the FireFox. I used the Netscape a long time ago. I used to keep the Netscape, Opera, and Firefox to test websites then I decided I just didn't care if my sites worked on anything besides IE.
Kerry

DanEpps · Post by **DanEpps** » Sat, Dec 30 2006, 5:27PM

I used to use Netscape as well but I haven't for a long time. I may have to try it again.

Thermwood / eCabinet Systems

bug

bug

zipped

Re: