HSF's end up looking weird...

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Lorin Holzbauer
New Member
Posts: 14
Joined: Mon, Feb 20 2006, 5:54PM

HSF's end up looking weird...

Postby Lorin Holzbauer » Sat, Jan 06 2007, 3:56PM

I'm running into an issue with display objects. the double sink from the supplied librarles in this example. When I place it into the job, it looks fine for a while. Then after changing views from overhead to wall, all of a sudden it ends up distorted, like it's from the Bazzaro world. It looks as though some of the vertexes that create the curves are being lost somewhere along the line.

I'm assuming it's something I'm doing, though this seems to happen from only changing views. Is this due to some misuse of the tool on my part? Is there a way to prevent or correct this distortion? Once it happens it seems that the only way to correct it is to replace the display object.

Any hints on this would be appreciated.
TIA
Attachments
BizzaroSink.jpg
BizzaroSink.jpg (82.33 KiB) Viewed 654 times

Joe Soto
Guru Member
Posts: 326
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

Postby Joe Soto » Sat, Jan 06 2007, 4:17PM

Sometimes they look like they fell off a truck. Try the enhanced view button, that should fix it.
Joe

Dickey Beckham
Junior Member
Posts: 58
Joined: Sat, Aug 13 2005, 4:21PM
Location: Arkansas

Postby Dickey Beckham » Sat, Jan 06 2007, 4:22PM

I have had the same look on the sinks in cabinet/assemble editor but when you go the custom layout and do a presentation View it will came
out looking good.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests