rotatr countertop in part editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

John Scaravella
Junior Member
Posts: 50
Joined: Tue, Jun 13 2006, 4:13PM
Location: NJ
Contact:

rotatr countertop in part editor

Postby John Scaravella » Sun, Jan 07 2007, 2:45AM

I brought the countertop into part editor to cut out the sink but the countertop appears at an angle on the page :? . when I try to make a rectangular cutout it is not square to the countertop edge. all other parts I have modified have appeared in part editor square to the page. how do I rotate the countertop on the page so I can make a rectangular cutout?
John

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Sun, Jan 07 2007, 9:43AM

You can't rotate objects in the part editor.

What you have to do is go into contour mode in the part editor and use the line tool to outline your cutout. Make sure the lines extend past the intersections and trim them using the trim tool.

Then exit contour mode and cut out the shape.

John Scaravella
Junior Member
Posts: 50
Joined: Tue, Jun 13 2006, 4:13PM
Location: NJ
Contact:

thanks

Postby John Scaravella » Sun, Jan 07 2007, 11:58AM

thanks Dan, I'l give it a try
John


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 7 guests