conestoga doors not routing profile on top edge.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Brian Bauer
Guru Member
Posts: 365
Joined: Tue, Sep 20 2005, 8:22PM
Location: Lower Lake, California
Contact:

conestoga doors not routing profile on top edge.

Postby Brian Bauer » Mon, Jan 15 2007, 8:58PM

Take a look at this first time I have seen this.
Doors not routing edge detail on top edge.

Brian Bauer
Attachments
no rout on top of door.jpg
no rout on top of door.jpg (66.64 KiB) Viewed 989 times
ballard above fridge upper.hsf
(257.6 KiB) Downloaded 80 times
Wood is wood , Particle Board is just dust !

User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 974
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Postby Brian Shannon » Mon, Jan 15 2007, 11:37PM

Brian,


I messed with this cabinet for a while. That door is giving me all sorts of edge profile problems. Cannot rebuild bottom rail. Other Calistoga doors seem O.K.. Odd...


Brian

Michael Yeargain
eCabinets Beta Tester
Posts: 1738
Joined: Tue, May 17 2005, 8:33PM
Company Name: Timeless Cabinetry and Mantles
Location: South East
Contact:

Postby Michael Yeargain » Tue, Jan 16 2007, 12:33PM

I mentioned in an earlier post there was an issue with some of the doors. It seems to have appeared in the latest build. I think it was with the stile and rail doors. mitered doors didn't have this problem.
Windows 7 Pro/10 Pro 64 bit
AMD Phenom 9650 Quad-Core Processor 2.3Ghz 8GRAM 1TB
NVIDIA GeForce GT 220 1GB

User avatar
Brian Bauer
Guru Member
Posts: 365
Joined: Tue, Sep 20 2005, 8:22PM
Location: Lower Lake, California
Contact:

Postby Brian Bauer » Tue, Jan 16 2007, 1:40PM

I was just wondering it doesn't look so good on the presentations.
Maybe something else for the programmers to look at :wink: .

Keep up the good fight busy programmers, Any word yet on the cutlist summary yet?Just finished a job and looked at it whoa, Little shy on the materials.

Brian Bauer
Wood is wood , Particle Board is just dust !

Michael Yeargain
eCabinets Beta Tester
Posts: 1738
Joined: Tue, May 17 2005, 8:33PM
Company Name: Timeless Cabinetry and Mantles
Location: South East
Contact:

Postby Michael Yeargain » Fri, Jan 19 2007, 12:11PM

Brian,

I'm sure they are solving this in the next build/version. There has been suggestions made to calculate board foot instead of the way we all see it now. Inches.
Windows 7 Pro/10 Pro 64 bit
AMD Phenom 9650 Quad-Core Processor 2.3Ghz 8GRAM 1TB
NVIDIA GeForce GT 220 1GB


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 8 guests