I work at a place that uses e-cabs now(no I work on the floor) however they asked me to look at a display panel they were trying to cut...
Basically a panel with a 1/4x 3/8 dadoe off one long side...well when I used the part editor everything went well however when we went to nest it no dadoe was present....I believe they solved it (by callinbg Thermwood) however I was curious as to why it does not nest correctly?
Roger
nesting and cutting edited display panels
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
nesting and cutting edited display panels
Wood Butcher/Case Maker