custom layout

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Don Nichelson
Junior Member
Posts: 65
Joined: Thu, Aug 24 2006, 1:49AM

custom layout

Postby Don Nichelson » Fri, Jan 26 2007, 1:12PM

When I am in custom layout and try to place a designed cube into an entertainment center I cannot get it to the right height to fit into the faceframe. As a matter of fact it is half below the floor. I've done it in the past but can't seem to figure it out right now. What am I doing wrong?

Wally Schneeberger
Guru Member
Posts: 473
Joined: Tue, May 17 2005, 1:55PM

Re: custom layout

Postby Wally Schneeberger » Fri, Jan 26 2007, 1:47PM

Don Nichelson wrote:When I am in custom layout and try to place a designed cube into an entertainment center I cannot get it to the right height to fit into the faceframe. As a matter of fact it is half below the floor. I've done it in the past but can't seem to figure it out right now. What am I doing wrong?


Highlite your cube and RC on the wall and then --Associte to wall -- Then go to the elavation of that wall and use the hift key along with the up arrow to move up.
Image


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Google [Bot] and 8 guests