custom layout
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 65
- Joined: Thu, Aug 24 2006, 1:49AM
custom layout
When I am in custom layout and try to place a designed cube into an entertainment center I cannot get it to the right height to fit into the faceframe. As a matter of fact it is half below the floor. I've done it in the past but can't seem to figure it out right now. What am I doing wrong?
-
- Guru Member
- Posts: 477
- Joined: Tue, May 17 2005, 1:55PM
Re: custom layout
Highlite your cube and RC on the wall and then --Associte to wall -- Then go to the elavation of that wall and use the hift key along with the up arrow to move up.Don Nichelson wrote:When I am in custom layout and try to place a designed cube into an entertainment center I cannot get it to the right height to fit into the faceframe. As a matter of fact it is half below the floor. I've done it in the past but can't seem to figure it out right now. What am I doing wrong?