drawer handles

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Jonathan Lester
Senior Member
Posts: 133
Joined: Thu, May 25 2006, 9:29AM
Location: Carleton Place, Ontario
Contact:

drawer handles

Postby Jonathan Lester » Mon, Jan 29 2007, 9:32AM

Hello again
Is there a way to put 2 handles on one drawer front?

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Mon, Jan 29 2007, 10:10AM

Yep...just click the second pull box and enter the location for both pulls.
Attachments
Pulls.jpg
Pulls.jpg (53.42 KiB) Viewed 759 times

Todd Miller

Postby Todd Miller » Mon, Jan 29 2007, 10:19AM

Yes you can!

Pull up you cabinet in the cabinet editor. Add your drawer(s)

First, go in to the door/drawer editor.
Next, click on the hardware selection tab
Choose your hardware. Make sure you choose the \"select as default
drawer pull\" tab. This will associate the pull to the drawer front.
Then, highlight the drawer face with a single click.
Next, click add/locate pulls.
Make sure you have the \"second drawer pull\" box checked.

Enter your values and hit ok.

Note: If you leave the location values set to center, and have the \"second drawer pull\" box checked, nothing will happen.

Todd Miller

Postby Todd Miller » Mon, Jan 29 2007, 10:20AM

Thanks Dan!


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Stuart Douglas and 7 guests