drawer handles

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Jonathan Lester
Senior Member
Posts: 133
Joined: Thu, May 25 2006, 9:29AM
Location: Carleton Place, Ontario

drawer handles

Post by Jonathan Lester »

Hello again
Is there a way to put 2 handles on one drawer front?
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Post by DanEpps »

Yep...just click the second pull box and enter the location for both pulls.
Attachments
Pulls.jpg
Pulls.jpg (53.42 KiB) Viewed 4334 times
Todd Miller

Post by Todd Miller »

Yes you can!

Pull up you cabinet in the cabinet editor. Add your drawer(s)

First, go in to the door/drawer editor.
Next, click on the hardware selection tab
Choose your hardware. Make sure you choose the \"select as default
drawer pull\" tab. This will associate the pull to the drawer front.
Then, highlight the drawer face with a single click.
Next, click add/locate pulls.
Make sure you have the \"second drawer pull\" box checked.

Enter your values and hit ok.

Note: If you leave the location values set to center, and have the \"second drawer pull\" box checked, nothing will happen.
Todd Miller

Post by Todd Miller »

Thanks Dan!
Post Reply