Is there an easy technique to aligning a geometry to the center of a square or rectangular panel? If I put a 2\" diameter circle on a square back panel, is there quick way to align to center, or do I need to figure the width height of the back panel and change the object move and move with the keyboard arrows?
Thanks,
Fred
part editor alignment
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 167
- Joined: Tue, Oct 03 2006, 6:51PM
- Location: Phoenix, AZ
- Contact:
part editor alignment
Fred Hirsch
-
- Senior Member
- Posts: 167
- Joined: Tue, Oct 03 2006, 6:51PM
- Location: Phoenix, AZ
- Contact: