counter top modifications

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Jonathan Lester
Senior Member
Posts: 133
Joined: Thu, May 25 2006, 9:29AM
Location: Carleton Place, Ontario
Contact:

counter top modifications

Postby Jonathan Lester » Thu, Feb 01 2007, 3:56PM

So Im almost done my first complete room layout since taking the ecab training course. Its taken a little longer than anticipated but such is the learning curve. Hopefully this is my last question regarding this kitchen. Is it possible to make a counter top in the c/t editor and then modify it?
thanks for all the help.

Todd Miller

Postby Todd Miller » Thu, Feb 01 2007, 4:49PM

Modify it how? If you want to change the parameters, DC the countertop while detailing the room in the custom layout view. RC and goto \"Counter top\" then Edit counter top.

But if you want to cut out a hole for a sink, you could take a display board that is the same size as the CT into the Part Editor. Then cut out your sink hole. Then apply that to your cabinets in the Custom layout view. You will have to manually apply a back plash th e same way.

Jonathan Lester
Senior Member
Posts: 133
Joined: Thu, May 25 2006, 9:29AM
Location: Carleton Place, Ontario
Contact:

Postby Jonathan Lester » Thu, Feb 01 2007, 4:56PM

sorry I guess I should have been more specific. I need to cut the counter around columns and pillars in corners. I figured I could do it as a display part I was just wondering if its possible to do it with the counter top because that would be neat.

Todd Miller

Postby Todd Miller » Thu, Feb 01 2007, 5:10PM

Jonathan,
As of now, no. That is not possible in the CT editor. You will have to use a display panel and the part editor..

Michael S Murray
eCabinets Beta Tester
Posts: 933
Joined: Tue, May 17 2005, 2:48PM
Location: Logansport, In
Contact:

Postby Michael S Murray » Thu, Feb 01 2007, 5:54PM

You can take a countertop created in the countertop editor into the part editor and make cuts on it.....
Mike Murray
Versatile Cabinet & Solid Surface
mike@versatilecabinet.com
http://www.versatilecabinet.com

User avatar
Kerry Fullington
Wizard Member
Posts: 4566
Joined: Mon, May 09 2005, 7:33PM
Company Name: ProSource of Amarillo
Country: UNITED STATES
Location: Amarillo, TX

Postby Kerry Fullington » Thu, Feb 01 2007, 7:52PM

Jonathan,
As Michael said, in Detail room double click to highlight the counter top that you want to edit then right click and choose Part Editor. This will send the top to the part editor where you can cut holes profile edges, whatever you want.
Kerry

Todd Miller

Postby Todd Miller » Fri, Feb 02 2007, 8:41AM

Jonathan,
I apologize for giving you false info. Thank you Kerry and Michael for correcting me.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests