Small layouts when printing. Help please

Steve Dyches · Post by **Steve Dyches** » Fri, Feb 02 2007, 8:26AM

When I print my layouts of panel parts some pages print with smaller layouts than others. Can I control this? Some are hard to read and they don't need to be printed so small.

Thanks,

Steve Dyches

DanEpps · Post by **DanEpps** » Fri, Feb 02 2007, 8:51AM

Are you talking about printing nest diagrams? You can zoom in on the page before printing if you want to make it larger.

Steve Dyches · Post by **Steve Dyches** » Fri, Feb 02 2007, 11:22AM

Hi Dan,

Yes, I'm talking about Nest Diagrams. I just printed 24 pages of a batch of cabinets. I see where I can click on the individual sheets and view them individually. As such I can zoom my view in and out but that doesn't seem to have anything to do with my printing. They are all 4x8 sheets. I would have expected that the 4x8 sheet layout (nest) would all be printed the same size on each of the 24 pages.

Steve

Forrest Chapman · Post by **Forrest Chapman** » Fri, Feb 02 2007, 2:57PM

Steve,

I left you a phone message, did you get it? One way that you can print and control the size is to change the button on the tool bar from job to veiw and zoom and position the sheet then go to file/preveiw and make sure its in the right place. I also will print landscape to get the biggest veiw.

Forrest