Hey hows it all going?
I got a cabinet here that when i put 2 partions in and = them up and take the left 1 out the 3mm holes in the deck stay in the deck and wont go away no matter wot. if i go to construion settings and press ok still wont make the holes go way.
Wot would cause this?
Thanks
Thom Davies
Holes that wont go away!
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
-
- Senior Member
- Posts: 109
- Joined: Mon, Jun 20 2005, 9:00PM
- Location: Calgary Alberta
-
- Guru Member
- Posts: 640
- Joined: Tue, Jan 16 2007, 7:56PM
- Company Name: LRG WoodCrafting
- Location: Windsor Locks, CT
- Contact:
They went away for me. I took your cabinet to the partition/shelf editor and deleted the partition. Then I went back to the main editor and they were gone. Then I went back and I added two partitions and and went to the main editor and there were holes for both partitions. Then I went back into the partition/shelf editor and deleted the 2nd partition and went back to the main editor and the holes were gone. Seems to be working to/for me.