Drying Racks

Sharon Beauchamp · Post by **Sharon Beauchamp** » Sun, Feb 04 2007, 12:28PM

This may not be the proper part of this forum to ask this and if so please someone direct me.

In our shop we are in desperate need of better using our spray booth area. We are tying up the booth too long for dry time. I would like to find information on drying racks, roll arounds, drying areas and things of this nature. This may have been discussed here before and if so please direct me to archives. If there are other sites anyone can recommend I will appreciate very much.

Sharon

DanEpps · Post by **DanEpps** » Sun, Feb 04 2007, 2:08PM

Sharon

Here is a thread on finishing booths from a while back that has a couple of pictures of racks. It may give you some ideas.

http://www.thermwood.com/forums/viewtopic.php?t=4406

Joe Soto · Post by **Joe Soto** » Sun, Feb 04 2007, 3:58PM

Here is a link to some racks. http://www.woodworkerswholesale.com/Mat ... _s/710.htm
Joe

DaleKern · Post by **DaleKern** » Sun, Feb 04 2007, 5:31PM

Sharon,

Joe's link is where it is at. The Hafele HR2 and Panaflex racks let you move panels/parts/molding out of the spraybooth after they have flashed off (dustproof) and wheel them into an area to fully cure.

Dale