Quick question, I think!

Brian Nichols · Post by **Brian Nichols** » Thu, Feb 08 2007, 10:20AM

Can I take a profile shape from the shape manager to the line drawing editor so I can print it out for use in a presention. Brian

DanEpps · Post by **DanEpps** » Thu, Feb 08 2007, 10:43AM

No but you can create a profile on a display board/panel/cube and take THAT to the line drawing editor. Just rotate it so you have an end view and you're set!

Kerry Fullington · Post by **Kerry Fullington** » Fri, Feb 09 2007, 7:58AM

Brian,
You can use the Print Screen key on your keyboard then open that image in Irfanview and crop the image of the profile to print it out
Kerry

Mike Seisser · Post by **Mike Seisser** » Fri, Feb 09 2007, 8:38AM

Kerry,

OK, I gotta ask. WTH is that profile for?

Mike

Kerry Fullington · Post by **Kerry Fullington** » Fri, Feb 09 2007, 8:47AM

That profile belongs to another eCab member (sorry I can't remember who). There was a problem with closing the contour or something quite a while back and I was just working on it. It was for a mantel base I think. I posted it because it is an interesting profile.
Kerry

Mike Seisser · Post by **Mike Seisser** » Fri, Feb 09 2007, 9:10AM

Kerry,

I see. It's definitely complicated, and seems well planned out. (I'm trying to picture it incorporated into a mantle now.)

Mike

Kerry Fullington · Post by **Kerry Fullington** » Fri, Feb 09 2007, 1:39PM

Mike,
Here is a link to the post where I downloaded the profile. Dan got the problem fixed before while I was downloading.
http://www.thermwood.com/forums/viewtopic.php?t=4643
Kerry