Last night I had a partially finished moch-up design for a comercial bar that was 1/2 done, so I saved it to disk and brought it up on my laptop at home. I finished the last 2 assemblies (Bar tops) and placed them in the room. When I tried to adjust palcement, the software wouldn't change the Move Increment Value. I got tired of messing with it and saved it. When I brought it up this morning, my bar cabs & tops are missing from the layout. I tried to save & reopen again after adding them, and same result. Can't change the Move Increment Value, and My Bar Cab assemblies are missing.
I'm stumped
Strange issue in Room layout
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 53
- Joined: Tue, Sep 26 2006, 9:02PM
- Location: lawrenceville, GA
-
- Junior Member
- Posts: 53
- Joined: Tue, Sep 26 2006, 9:02PM
- Location: lawrenceville, GA
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
-
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
We got this straightened out.
Jeff had copied backup files from his office computer to a CD and restored them to his home computer.
Apparently his anti-virus software changes files copied from a CD to read-only and he couldn't rewrite them. Changing the permissions took care of the problem.
The question for Thermwood though is, why was he not getting any error messages when he tried to change the move increment or save the job file?
both the job file and ecabinets.ini were read-only.
Jeff had copied backup files from his office computer to a CD and restored them to his home computer.
Apparently his anti-virus software changes files copied from a CD to read-only and he couldn't rewrite them. Changing the permissions took care of the problem.
The question for Thermwood though is, why was he not getting any error messages when he tried to change the move increment or save the job file?
both the job file and ecabinets.ini were read-only.
-
- eCabinets Beta Tester
- Posts: 414
- Joined: Tue, May 10 2005, 9:58AM
- Location: Bellingham, Washington
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA