Countertop edging, how?

Peter Walsh · Post by **Peter Walsh** » Sun, Feb 18 2007, 12:37PM

I rarely run into a project requiring a counter top, but now have one.

I want to use a Formica top with a wood cherry edging across all front edges. I can't see how I can do this with the counter top editor, etc.
Maybe some of you guys who work with counter tops regularly have figured this out? I don't need this for CNC, mainly to include it in the sales presentation rendering.
Any ideas?

Thanks,

DanEpps · Post by **DanEpps** » Sun, Feb 18 2007, 1:55PM

Display cubes Peter, display cubes. Just like version 4 before countertops were included.

Kerry Fullington · Post by **Kerry Fullington** » Sun, Feb 18 2007, 2:28PM

Peter,
This is one display cube with the center cut out and a profile run on the edge for the wood and another display cube for the marble center.
Kerry

Peter Walsh · Post by **Peter Walsh** » Sun, Feb 18 2007, 7:17PM

OK,
Thanks guys, I figured it was going to be a display part type job but, hope springs eternal.
thanks again,