Fixture for holding board stock

Zach Froble · Post by **Zach Froble** » Sun, Feb 18 2007, 2:42PM

At the IWF show I remember some type of fixture they were using to hold the board stock in place while running mouldings. Is this something that is available from Thermwood. I can't remember exactly what it look like or how it even worked, but I would be interested in some more info.

Thanks,

Zach

Michael S Murray · Post by **Michael S Murray** » Sun, Feb 18 2007, 5:03PM

Hey Zack, they were cutting 5 pc doors if I am remembering right. They were just using some kind of staco clamps or similar, and I do beleive I remember some one from thermwood mentioning in another post that they were available, maybe some one will jump in monday.

Kerry Fullington · Post by **Kerry Fullington** » Sun, Feb 18 2007, 5:25PM

There is an article on the five piece door system in the latest member magazine that shows the hold down fixture.
Kerry

Zach Froble · Post by **Zach Froble** » Mon, Feb 19 2007, 11:24AM

Michael and Kerry,

I fixture I am referring to was holding the board stock that they were cutting the mouldings for the Credenza. It held 8' long board stock that they carved the mouldings from. I am familiar with the fixture for the five piece doors, but the one I remember was similar to the rotary play back device but longer.

Michael S Murray · Post by **Michael S Murray** » Mon, Feb 19 2007, 11:31AM

zack,
I must have missed that, you might try e-mailing Jody Wilmes directly, he would be the one actually using it..I have the rotary playback , dont think they make it in any thing longer? Definetly have been wrong before though!