Creating a built in appliance cabinet, need help
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
George L Vought
- Junior Member
- Posts: 85
- Joined: Fri, Feb 16 2007, 2:00PM
Creating a built in appliance cabinet, need help
I took a frameless cabinet into cabinet editor, brought in a display cube to use as my appliance, but can't figure out how to get it placed \"inside\" the cabinet far enough. Am I using to big of a display cube?
-
Pete Riddle
display cube
George,
I'm not clear on all of your actions here, but once you have the cube in the cabinet editor go to a left or right view. Then single (left) click on the cube. At this point you can hold down your <shift> key and use your arrow buttons to locate your cube. The amount it moves is determined by the your movement increment.
I'm not clear on all of your actions here, but once you have the cube in the cabinet editor go to a left or right view. Then single (left) click on the cube. At this point you can hold down your <shift> key and use your arrow buttons to locate your cube. The amount it moves is determined by the your movement increment.