MDF drawer not nesting correctly
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
MDF drawer not nesting correctly
I can get the drawer front to nest but the profile does not show up on the nest...
Wood Butcher/Case Maker
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
Joe...
Here is a picture of what I am talking about...I get the issue with the edge profile on the drawers but the inner profile, groove or bead or whatever we call it... is not nesting or showing up on the G-code after the TWD file is run...
I will hopefullyt be doing MDF doors here shortly..this is the first step in figuring it out...
Thanks again
Here is a picture of what I am talking about...I get the issue with the edge profile on the drawers but the inner profile, groove or bead or whatever we call it... is not nesting or showing up on the G-code after the TWD file is run...
I will hopefullyt be doing MDF doors here shortly..this is the first step in figuring it out...
Thanks again
- Attachments
-
- dfronts.jpg (50.78 KiB) Viewed 6554 times
Wood Butcher/Case Maker
-
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
Joe,
Here is the job file...everything is run on 3/4 because we will be using whatever scrap we have to run this test...I changed the profile a little and got the front dovetails to nest but the inner bead on the d-fronts still wont go..
There is no \"thermwood\" option to run drawer fronts in the designer
I used the MDF drawer function in the door drawer designer... to make them..
Here is the job file...everything is run on 3/4 because we will be using whatever scrap we have to run this test...I changed the profile a little and got the front dovetails to nest but the inner bead on the d-fronts still wont go..
There is no \"thermwood\" option to run drawer fronts in the designer
I used the MDF drawer function in the door drawer designer... to make them..
- Attachments
-
- AMSL.esj
- (3.05 MiB) Downloaded 281 times
Wood Butcher/Case Maker
-
- Guru Member
- Posts: 367
- Joined: Thu, May 19 2005, 7:50PM
- Company Name: Fancyridge Wood Products LLC
- Location: Greensburg, Ky
Roger, I get the tool is not valid in the door/drawer designer for the interior tool on the drawer front called dadoe.tol so that may be the problem but if I select the default door it shows the mitre.tol that looks like the pic you posted should they be the same? . Are you trying to do a 1 pass front or model it out usin the profile modeler? Give this a look.
Joe
Joe