having some problems
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 4
- Joined: Fri, Jan 05 2007, 11:00PM
having some problems
I am working in the shap manager making cutter and whenever i go to put a measurement in for a line it draws the line at an angle but i dont have any of the angle snaps on. When i just draw a line using ortho with no measurements it works. How do i fix this?
-
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Eric
What I think you might be seeing is the end point of a line attached to the cursor. This happens when you enter the beginning coordinates and the cursor is located away from the starting point.
Once you enter the ending coordinates and press enter the line will be placed according to the coordinates you entered.
What I think you might be seeing is the end point of a line attached to the cursor. This happens when you enter the beginning coordinates and the cursor is located away from the starting point.
Once you enter the ending coordinates and press enter the line will be placed according to the coordinates you entered.