V5.1 Error adding doors

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

V5.1 Error adding doors

Postby DanEpps » Thu, Mar 01 2007, 12:32PM

Base cabinet, sheet stock face frames with puzzle joints...

When trying to add CRP-10 double doors I am getting the error in the attached image.
Attachments
Error Adding Doors.jpg
Error Adding Doors.jpg (43.8 KiB) Viewed 2144 times

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Thu, Mar 01 2007, 12:42PM

Update: I removed all part editor cuts from the cabinet and was able to add the doors. I was then able to put part editor cuts back on the cabinet.

Additional information: The CRP-10 doors we configured with a C profile and were inset into the face frames.

User avatar
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Postby Scott G Vaal » Thu, Mar 01 2007, 12:47PM

Dan,

Can you please post the cabinet the way it was when you were getting the message? Thanks.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Thu, Mar 01 2007, 12:53PM

I don't have it anymore but if you try to remove the doors from this one you will get the same error.
Attachments
Base Assy 1.zip
(1.33 MiB) Downloaded 140 times

Walker T Scott

Postby Walker T Scott » Thu, Mar 01 2007, 1:14PM

Dan,

What kind of parte editor cuts did you have on the cabinet and where?

Thanks

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Thu, Mar 01 2007, 1:27PM

This cabinet has all of the cuts on it. The top has a profiled edge, both ends and both face frame stiles are raised using MDF assymetric #4.

Removing the cuts did not help though until I saved the cabinet WITHOUT the cuts. Once I did that I could add the doors and cuts back to the cabinet.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 8 guests