Problems with saving geometry created in part editor contour

Kirk Newson · Post by **Kirk Newson** » Sat, Mar 03 2007, 7:59AM

When I Create geometry in the part editor, Contour area, on the right side of the cabinet I am able to lock it in, and save it thru the Constraint Manager.
When I do the same geometry on the Left side the Constraint Manager does not recognize it
If I create the geometry last, save the cabinet, and send it to the machine, it seams to cut fine, but if I make any changes the right side geometry remains but the left side geometry is gone.
Can any one explain how to keep the geometry on both sides so a cabinet can be modifed after geometry is placed.

Leo Graywacz · Post by **Leo Graywacz** » Sat, Mar 03 2007, 8:00PM

Are you associating the cabinet sides to the cabinet after you put the holes and constraints in them?

Kirk Newson · Post by **Kirk Newson** » Sat, Mar 03 2007, 11:35PM

As the Constraint Manager dosen't Reconize any geometry or cuts. Therefore there are no cuts associate the part to the cabinet