Associate Holes

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Douglas Nelson
New Member
Posts: 4
Joined: Sat, Feb 10 2007, 5:46PM
Location: Henderson, NV

Associate Holes

Postby Douglas Nelson » Wed, Mar 14 2007, 3:54PM

Hello,
This is my first post. I have used eCab since ver. 2, but just joined the forum. Most of my work is in remodeling or in matching existing cabinets or duplicating something the customer already has. I have not used all of the features, but, I'm trying to learn. My question today is about holes associtated with hinges. When sclecting a hinge and associating a hole pattern, the file reads something like this:
\"hinge-Salice-Series200-bore_3.ptn\". Is the the number at the end, in this case a 3, the tab distance on the door?

This software is the best and Thanks to Eric and Thermwood I have my software running again.

Thanks
Doug

User avatar
Roger Erismann
Senior Member
Posts: 169
Joined: Sun, Dec 04 2005, 11:42PM
Location: Sacramento, CA and Rolla, Mo

Postby Roger Erismann » Wed, Mar 14 2007, 11:17PM

Usually that is the case...with Blum hinges in the whole pattern file...you can allways load up a hinge and then use the line drawing editor to verify your bore distance
Wood Butcher/Case Maker

Douglas Nelson
New Member
Posts: 4
Joined: Sat, Feb 10 2007, 5:46PM
Location: Henderson, NV

Postby Douglas Nelson » Wed, Mar 14 2007, 11:23PM

Thanks Roger, that really helps.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests