Add doors to Library

[Russell Walker]

Hi All

Our we able to play around with doors etc. in the part editor and save then in the relevant library for future use? I have just completed a kitchen with 23 doors along with 8 drawers, and had to do each front seperately. I was hoping to do one that saved as a default for the others.

Cheers Russell

[Michael Yeargain]

Yes Russell,

You can modify any of the doors and save them into another directory to be used at a later time. Once you get the door the way you want. Click on the save button and give it a name and directory.

[Mike Seisser]

Russell,

At this time doors aren't supported in the Part Editor. Also, I'm pretty sure that you can't batch these doors either. Do you have a need to add doors/drawerfronts to a batch and be able to resize them on the fly?

Mike

[Michael Yeargain]

Russell,

At this time doors aren't supported in the Part Editor. Also, I'm pretty sure that you can't batch these doors either. Do you have a need to add doors/drawerfronts to a batch and be able to resize them on the fly?

Mike

Yea like he said.

[Russell Walker]

Hi All

No Mike, I just did them as I went along with the said kitchen, I just thought how frustrating and time consuming to go the way I was. It would be good to be able to save it all and be able to resize them as I go.

Cheers Russell

[Russell Walker]

Hi All

Thankyou also Michael, I haven't tried doing that operation either; I will give it a go.

Cheers Russell