Error sharing .esj file

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Bill Ward
New Member
Posts: 14
Joined: Sat, Oct 01 2005, 9:19PM
Location: Huxley, IA

Error sharing .esj file

Postby Bill Ward » Sat, Mar 17 2007, 11:28AM

I sent an .esj file to another user to look at and he gets the following when opening it. When he opens the file it says \"Unable to open Ecabinets file data\" and then says \"There was an error after opening the JOB file.\"

I am still running v5 build 12. He has the latest update (as of this morning) so it must be v5.1 build 2.

For him to open my room layout, I should only have to send him the .esj file, correct? It has cabinets I have created and saved, as well as assemblies, which were all created from the basic eCabinets install. (No special 3D files or appliances or anything else which I might have added.)

I would like to know if there is something more that the .esj file I need to send him. (I haven't had to share before, all my work had been done on one PC.)

Thanks,
Bill

Forrest Chapman
eCabinets Beta Tester
Posts: 1097
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Postby Forrest Chapman » Sat, Mar 17 2007, 11:40AM

Bill,

If you emailed the file then you may need to zip it. Ocasionaly bad files have something to do with the email provider and may need to be sent again. You can also try posting the file in a private message on this site and sending it to him.

Forrest

Bill Ward
New Member
Posts: 14
Joined: Sat, Oct 01 2005, 9:19PM
Location: Huxley, IA

Postby Bill Ward » Sat, Mar 17 2007, 12:17PM

Thanks Forrect, I will try zipping first.
Bill

Bill Ward
New Member
Posts: 14
Joined: Sat, Oct 01 2005, 9:19PM
Location: Huxley, IA

Postby Bill Ward » Sat, Mar 17 2007, 7:43PM

I zipped it up and sent it. It worked fine. Thanks for the advice!


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 17 guests