Can anyone tell me why an improrted jpeg appears rotated when it is applied to display part. I know I can scale and rotate the material in the DPE, but it does not line up well. Is there a work around to get a better end result.
Thanks,
KB
Imported jpegs to Materials/User defined folder
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Keith Beggarly
- Junior Member
- Posts: 53
- Joined: Wed, Jul 12 2006, 11:50AM
- Location: South Boston, VA
- Contact:
Imported jpegs to Materials/User defined folder
- Attachments
-
- BRICK05.jpg (4.98 KiB) Viewed 2120 times
-
- Imported jpeg.jpg (66.76 KiB) Viewed 2097 times
-
Kerry Fullington
- Wizard Member
- Posts: 4722
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Keith,
If you are applying the image in the Display Parts Editor it will be skewed. This has been a problem since version 1.
Use a display cube and save it as an assembly and your image should be OK.
Also make sure that your jpeg image size is divisible by 4. Yours at 128 pixels X 128 pixels is OK
Kerry
If you are applying the image in the Display Parts Editor it will be skewed. This has been a problem since version 1.
Use a display cube and save it as an assembly and your image should be OK.
Also make sure that your jpeg image size is divisible by 4. Yours at 128 pixels X 128 pixels is OK
Kerry