Hi - another issue - I'm attempting to change my slab doors from walnut to mahogany. This is being done on some assemblies. When I make the change, the lower cabinet of the assembly (where the doors are) jumps up halfway overlapping the upper cabinet in the assembly. I have to go into the cabinet editor to realign the cabinets.
Is this a bug, or something I'm doing wrong?
Thanks - Jason
P.S. I attached the job in my previous post, re: changing materials.
Changing doors in assemblies
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 533
- Joined: Thu, Jun 23 2005, 12:26AM
- Location: San Francisco
-
- New Member
- Posts: 17
- Joined: Tue, Jul 25 2006, 12:08AM
- Location: Valencia, CA