Moderators: Jason Susnjara , Larry Epplin , Clint Buechlein , Scott G Vaal
Al Navas
eCabinets Beta Tester
Posts: 443 Joined: Fri, Feb 17 2006, 5:22AM
Location: Near St Joseph, Missouri, USA
Contact:
Post
by Al Navas » Mon, Apr 09 2007, 6:34PM
1. Is it possible to specify tongue & groove as the construction method for cabinets? I use the Sommerfeld T&G router bit set for the cabs.
2. If so, how do I (or how would I) go about setting the preferences? Right now I don't see this as an option anywhere in 5.1, Build 2.
Thanks!
Kerry Fullington
Wizard Member
Posts: 4723 Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX
Post
by Kerry Fullington » Mon, Apr 09 2007, 7:42PM
Al,
I think you should be able to use the Mortise and Tenon joinery and adjust those parameters to make it tongue and groove.
Kerry
Al Navas
eCabinets Beta Tester
Posts: 443 Joined: Fri, Feb 17 2006, 5:22AM
Location: Near St Joseph, Missouri, USA
Contact:
Post
by Al Navas » Mon, Apr 09 2007, 8:40PM
Thanks, Kerry.
Would you believe, I started to go that route, stopped myself, and decided to post my question here? I must follow up on this and see where it takes me.
Thanks a bunch!!!
.