Tongue & groove to build cabinets in eCabinets?

Al Navas · Post by **Al Navas** » Mon, Apr 09 2007, 6:34PM

1. Is it possible to specify tongue & groove as the construction method for cabinets? I use the Sommerfeld T&G router bit set for the cabs.

2. If so, how do I (or how would I) go about setting the preferences? Right now I don't see this as an option anywhere in 5.1, Build 2.

Thanks!

Kerry Fullington · Post by **Kerry Fullington** » Mon, Apr 09 2007, 7:42PM

Al,
I think you should be able to use the Mortise and Tenon joinery and adjust those parameters to make it tongue and groove.
Kerry

Al Navas · Post by **Al Navas** » Mon, Apr 09 2007, 8:40PM

Thanks, Kerry.

Would you believe, I started to go that route, stopped myself, and decided to post my question here? I must follow up on this and see where it takes me.

Thanks a bunch!!!

.