Quadro Tweak Utility and Build 3

Al Navas · Post by **Al Navas** » Mon, May 07 2007, 5:27PM

Is it necessary to re-run the Quadro tweak utility after installing Build 3?

.

Post by **Dean Fehribach** » Thu, May 10 2007, 1:25PM

No, but re-running doesn't hurt (but doesn't help, either). The Quadro Tweak Utility puts information into nVidia's section of the registry where eCabinet Systems installs and upgrades don't write.

Curiously, why do you ask?

Al Navas · Post by **Al Navas** » Thu, May 10 2007, 4:41PM

Thanks, Dean.

I ask because I am being VERY cautious and will do ONLY what is recommended, after someone has tried it out. I did not want to run the utility after installing Build 3 if it was going to cause unexpected or unsuspected problems, Dean.