Error installing build 3

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Bill Rutherford
eCabinets Beta Tester
Posts: 386
Joined: Tue, May 10 2005, 5:23AM
Location: Lancaster, NH
Contact:

Error installing build 3

Postby Bill Rutherford » Mon, May 07 2007, 7:09PM

When I launch the installer for build 3, I get an error that says error reading setup initialization file. Please advise
Bill Rutherford
North Woods Manufacturing
Full service CNC Machining
and Edge Banding
http://www.northwoodsmanufacturing.com

User avatar
Bill Rutherford
eCabinets Beta Tester
Posts: 386
Joined: Tue, May 10 2005, 5:23AM
Location: Lancaster, NH
Contact:

Postby Bill Rutherford » Tue, May 08 2007, 6:43AM

Never mind - I re-downloaded the file and everything is fine.

One thing that was supposed to be addressed with this release was the incorrect placement of the edge banding on the part labels.

Edgebanding depiction on labels getting incorrect rotation. (FIXED WITH EXCEPTION) EXCEPTION: eCabinet Systems insures the inside of the cabinet is the side of the part which is facing up in the nest. (Shelves top side, Partitions right side, Toe front side) For double sided material eCabinets will make the side of part with the most operations be the side facing up in the nest. For these circumstances where eCabinets switches this orientation to not be the inside of the cabinet there is a possibility that the rotation will be inaccurate. This is being address in eCabinets and will be fixed in version 5.1 Build 3. Release of this build will be available in the near future.

Was this actually fixed?
Bill Rutherford

North Woods Manufacturing

Full service CNC Machining

and Edge Banding

http://www.northwoodsmanufacturing.com

User avatar
Larry Epplin
Thermwood Team
Posts: 644
Joined: Tue, May 17 2005, 12:44PM
Location: Thermwood

Postby Larry Epplin » Tue, May 08 2007, 9:34AM

Hi Bill. Yes the edgebanding depiction on labels was fixed for double sided material parts getting flipped in eCabinets to optimize cutting at machine. We failed to get it listed in the report.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 9 guests