Modifying drawer box pieces?

JohnJenkins · Post by **JohnJenkins** » Wed, May 16 2007, 2:39PM

Just wondering if anybody has been able to take a single drawer box part to part editor? I am needing to modify sides for a pantry rollout . I haven't found a way, any help is greatly appreciated.

Mark Hesketh · Post by **Mark Hesketh** » Wed, May 16 2007, 3:01PM

there is no way to take a drawer part into the part editor yet. it is something many of us are really looking forward to.

Michael Yeargain · Post by **Michael Yeargain** » Wed, May 16 2007, 6:01PM

Just for the record Mark & John this is on the wish list.