Hey Hows it all going?
I got a nice 1 here.
Its a panel thats 170mm square and 18mm thick. It has holes in it and thats not the problem. What i cant figure out is how to do the curve thats on the face. it goes down to 10mm in the middle of the board.
Can i run it with just the curve in it then nest the same size panel with the holes in it?
Thanks
Thom Davies
Need some Help PLEASE!
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
Need some Help PLEASE!
- Attachments
-
- P1010227.JPG (64.39 KiB) Viewed 3087 times
-
- P1010225.JPG (62.55 KiB) Viewed 3087 times
-
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
-
- Thermwood Team
- Posts: 857
- Joined: Tue, May 17 2005, 12:47PM
- Company Name: Thermwood
- Country: UNITED STATES
- Location: Thermwood
Re:
Kinda sounds like a job profile modeler could do.Thom Davies wrote: You made a tool to make that shape, Im going to be running them on the thermwood, just cos the tool was made to the shape do i need to have a tool that shape? Or can i do it with a bull nose cutter?
http://www.thermwood.com/twood_site/pag ... manual.pdf
Rick Deskins
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900
eCabinet Systems Programmer
Dell Precision / Xeon E3-1240 / 8GB RAM/ AMD FirePro V4900