Moderators: Jason Susnjara , Larry Epplin , Clint Buechlein , Scott G Vaal
Al Navas
eCabinets Beta Tester
Posts: 443 Joined: Fri, Feb 17 2006, 5:22AM
Location: Near St Joseph, Missouri, USA
Contact:
Post
by Al Navas » Mon, Jul 16 2007, 4:11PM
DanEpps wrote: What about the long time it takes after clicking the Define Costs button...is it just me?
Dan,
It takes a little less than one second on my machine, even with a very large assembly in the Cabinet/Assembly Editor.
Edit to add:
Question for Dan: Does it matter whether you are editing one cabinet or a large assembly?
Al
DanEpps
Wizard Member
Posts: 5852 Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA
Post
by DanEpps » Mon, Jul 16 2007, 4:19PM
Strange...it is consistantly 10 seconds on one computer but is instantaneous on another.
The funny thing is, the slow one is the highest horsepower workstation I have and the fast one is a laptop.
DanEpps
Wizard Member
Posts: 5852 Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA
Post
by DanEpps » Mon, Jul 16 2007, 5:07PM
I just forgot the most basic of Windows rules, reboot!!!
Al Navas
eCabinets Beta Tester
Posts: 443 Joined: Fri, Feb 17 2006, 5:22AM
Location: Near St Joseph, Missouri, USA
Contact:
Post
by Al Navas » Mon, Jul 16 2007, 5:27PM
Dan,
Does this mean that the machine that was slow to show the Dynamic Markups screen is now working OK?
Al
DanEpps
Wizard Member
Posts: 5852 Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA
Post
by DanEpps » Mon, Jul 16 2007, 5:53PM
Pretty much...there is still a very slight delay and a very fast screen flash before the cost screen is displayed. I'm not too concerned about it since I very rarely visit that area. I just thought it might be a problem that needed to be examined and didn't even think of checking it on another computer or rebooting first.