attached is the file that I am trying to render. It only renders about a third of the way and then the bottom 2/3 it renders black.
Does anyone have any ideas??
Thanks
John
P.S. I am using 5.1.3
Need some help with a drawing that will not fully render
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
-
- Wizard Member
- Posts: 4722
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
John,
I have this happen a lot. Look where the drawing stops rendering, it is probably at a pull or a rope molding or something else that is causing an overload. I get around it sometimes by saving the job then completely shutting down the computer (not just a re-start) then upon starting the computer up again go immediately to your render and try it while the computer still has a lot of resources. If it still hangs at that spot, remove the pull or molding that is causing it.
Kerry
I have this happen a lot. Look where the drawing stops rendering, it is probably at a pull or a rope molding or something else that is causing an overload. I get around it sometimes by saving the job then completely shutting down the computer (not just a re-start) then upon starting the computer up again go immediately to your render and try it while the computer still has a lot of resources. If it still hangs at that spot, remove the pull or molding that is causing it.
Kerry
-
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact: