Displaying Cabinet Hardware

Raymond Beausoleil · Post by **Raymond Beausoleil** » Wed, Jun 20 2007, 7:26PM

Is it possible to display cabinet hardware such as hinges and drawer runners? When you select pulls and knobs they get displayed at the designated locations but the associated hinges and runners don't. Atleast I haven't discovered the right parameters to get them to display.

Joe Dusel · Post by **Joe Dusel** » Wed, Jun 20 2007, 9:47PM

Sure it's possible to display them, but first you will need to draw them up. These are not rendered as display objects in the vendor databases.

Joe

Raymond Beausoleil · Post by **Raymond Beausoleil** » Thu, Jun 21 2007, 4:56AM

Ok, thanks!

George Davidson · Post by **George Davidson** » Thu, Jun 21 2007, 6:35AM

Raymond Here are some I made up
http://invite.filmloop.com/x?zcH0vpahSy ... ZOCHqwQUEj

Raymond Beausoleil · Post by **Raymond Beausoleil** » Thu, Jun 21 2007, 7:53PM

George,

Nice Work!

Ray