Assemblies in LDE

Tom Sherman · Post by **Tom Sherman** » Tue, Jun 26 2007, 11:51AM

This maybe has been discussed somewhere, but I didn't find it.

When you take an assembly from the Cabinet Editor to the LDE and then copy and paste, the copies are small. And when you bring them up to the same size as the original, the leader arrows get huge.

Mostly it's just an annoyance, but is it going to be addressed? For that matter, just for my own edification, why does it happen?

Tom

Justin Melhiser · Post by **Justin Melhiser** » Tue, Jun 26 2007, 2:22PM

Tom
Would you send me your assembly file and the steps you took to get the leader arrow an abnormal size? My email is cabinets@thermwood.com

Thank you
Justin Melhiser