importing DXF

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
jim graham
New Member
Posts: 15
Joined: Sat, Aug 26 2006, 9:06AM

importing DXF

Post by jim graham »

I am trying to import my Logo which i have saved as a dxf from turbo cad, but it wont load into the LDE. any ideas? i attached the file...
Last edited by jim graham on Tue, Jul 24 2007, 3:00PM, edited 1 time in total.
Justin Melhiser

Post by Justin Melhiser »

Jim

There is no files attached to the post. Could you post it again.

Thank You
Justin
jim graham
New Member
Posts: 15
Joined: Sat, Aug 26 2006, 9:06AM

Justin, your email address is invalid...

Post by jim graham »

Justin, i tried to send you an email reply but it wouldnt go thru. anyways, upon investigation, i found the forum doesnt allow dxf files, send me an email to jimswoodworks@frontiernet.net & i will send the file to you.
jim graham
Post Reply