Frustrated making angled cabinet!!!!

ScotAcree · Post by **ScotAcree** » Wed, Sep 12 2007, 9:48AM

I have my first kitchen job done in e cabinets.I have been able to design the square boxes fine.The client would like to have a angled transition base for a desk area.Cab. will be 15wX28.5hX18d on the rh side of a 18w file drw.

Are there any in the design sharing to be purchased,or can someone get me started?

It could be one angle or 135 degree ,I am building FF cabs.

Much appreciated
Scot Acree Woodworking,LLc

Michael Yeargain · Post by **Michael Yeargain** » Wed, Sep 12 2007, 1:49PM

The dimensions you gave are not setting right for a 135deg cabinet angle. But here is a base corner to help you get started.

Take a look at the settings.