Printing nest

David Werkheiser · Post by **David Werkheiser** » Wed, Sep 19 2007, 9:46AM

I am having problems when printing out nests, I have a list of 24 sheets but only want to print 1-8. The printer will print the 1st and 2nd. sheets with page numbers, than jump to sheets 11-18 with out page numbers. Also a box comes up on screen telling me that e-Cabs. needs to close.
I have tried using both of my printers, and the same thing happens.
I think I remember reading about this printing problem before, and I did a search but couldn't find it.
David Werkheiser

Justin Melhiser · Post by **Justin Melhiser** » Wed, Sep 19 2007, 1:07PM

David

Would you post this job you are trying to print? I would like to try and print it out here and see if I get the same results.

Thank You
Justin

Justin Melhiser · Post by **Justin Melhiser** » Wed, Sep 19 2007, 1:09PM

David

You could also email me the files if you would like. My email is cabinets@thermwood.com

Thank You
Justin

David Werkheiser · Post by **David Werkheiser** » Wed, Sep 19 2007, 2:32PM

Justin, sent you the files,(I hope), I noticed that after I hit the \"Perform Nest\" button, a box pops up \"not found in Sheet Stock for the.\"
When I print out a whole job of 24 sheets it starts out:
1-2 jumps ahead to 11-18, back to 3, ahead to 19-24, back to 4 , ahead to 25-26 and back to 5-10. Not a problem when printing out whole job, just resort, but sometimes there are sheets I don't want printed.
Thank you, David Werkheiser